EPCforce reads the tender and the owner's data, draws the P&ID, runs the calculations and assembles the document package for EPC engineering teams.
Seventeen engineering disciplines are mapped. The numbers below are counted from the product's own coverage matrix, which is checked against the code and its tests.
Each step hands a structured result to the next, so an engineer can open any document and see what it was built from.
Parse the tender and the technical specification into a requirements register.
Turn the description into a scheme: equipment, lines, instruments, zones.
Wall thickness, line sizing, heat and material balance, loads and cables.
P&ID, single-line diagrams and plans as DXF, SVG and PDF, laid out to the sheet rules.
Assemble the package with sheets, forms, maturity and responsibility marks.
Every customer works in its own isolated space. Nothing from one tenant is visible to another.
HAZOP screening, standards rules and sheet quality checks run next to the drawing, not after it.
DXF, SVG, PDF, DEXPI, IFC and CSV, so the result fits the tools the team already uses.
The run stops at checkpoints for the scheme and the HAZOP findings, and continues after an engineer approves.
What the product produces now, what it produces in part, and what is still planned.
P&ID drawing, equipment and line lists, heat and material balance, line sizing and a cost estimate from the owner's price book.
Pipe specification and MTO, schematic isometrics with a bill of materials, stress-critical lines with PCF, and an IFC check against the P&ID.
Loads, protection and cables from the catalogue, single-line diagrams, load table and cable journal, equipotential bonding. Plan sheets need a building model.
Principle scheme of conditioning, catalogue check of refrigerant lines and condensate drainage of indoor units. Heat load calculations are planned.
| № | Discipline | Status | Gap |
|---|---|---|---|
| 01 | Process / P&ID | In product | — |
| 02 | Process safety / HSE | Partial | LOPA and SIL targets |
| 03 | Instrumentation and control | Partial | Loop diagrams, I/O list |
| 04 | Mechanical: static equipment | In product | — |
| 05 | Mechanical: rotating equipment | Roadmap | Selection against vendor curves |
| 06 | Piping | In product | — |
| 07 | Electrical | Partial | Plan sheets need a building model |
| 08 | Telecom and low current | Roadmap | Cabling, CCTV, access control |
| 09 | Fire protection | Partial | Smoke control |
| 10 | HVAC and refrigeration | Partial | Heat load calculations |
| 11 | Plumbing and drainage | Partial | Water supply and sewer |
| 12 | Civil and structural | Partial | Foundations and structures |
| 13 | Architecture (coordination) | In product | — |
| 14 | Site, roads and networks | Roadmap | Plot plan, grading |
| 15 | Heat, gas and pipelines | Roadmap | Networks and routes |
| 16 | Materials, corrosion, insulation | Roadmap | Material and coating specifications |
| 17 | Environment and permitting | Roadmap | Emissions and discharge |
“In product” means the document generator exists and is covered by tests. It does not replace review by a licensed engineer.
Send a real tender or a process description. EPCforce reads it and returns the P&ID, the calculations and the document package. Your engineers review it at the checkpoints.